Banner SureCross DX80 Wireless Networks - Manual (Page 12)

3. Enter system as the user name and admin as the password.
After making your changes and saving the file, close the browser to log out of the configuration system.
3.2 Saving the System Configuration
Save the system configuration by going to the System > Setup > Config File page.
• To write the changes to the factory default XML file (BootConfig.xml), click the Save button.
• To save the configuration changes under a different file name, enter the new XML file name, including the .XML
extension, in the New File Name box and click the Save As button.
To define which XML configuration file loads when the device cycles power or restarts, enter the file name in the Startup
Configuration box.
Cycle power to the Ethernet Bridge or GatewayPro to complete this update. After the device powers up, the changes
should be registered.
3.3 Enabling EtherNet/IP Communication Protocol
By default the Ethernet Bridge and GatewayPro systems communicate using Modbus/TCP, but the system can also use
EtherNet/IP ™ .
To change the system to EtherNet/IP, log in using the following user name and password.
User name: root
Password: sxi
At the bottom of the System > Setup > Network page is a checkbox to enable EtherNet/IP. Only select this box if the
GatewayPro system is running on an EtherNet/IP network. This change cannot be enabled from a login other than the
“root” login.
After selecting the EtherNet/IP Enabled checkbox, click the Set Ports button to save any changes made to the HTTP Port,
Modbus Server Port, Telnet Port, and EtherNet/IP Enabled box. Cycle power to the Ethernet Bridge or GatewayPro to
complete this update. After the device powers up, the changes should be registered.
For some SureCross devices, the Ethernet/IP checkbox may be enabled as the factory default.
Host Controller Systems
12