Kenco Engineering SmartSonic Transmitter (Remote) - Manual (Page 30)

Page 30
ADDITIONAL FEATURES
This section describes the functions available in SmartSonic Remote's additional menu. The additional menu functions
enable you to calibrate SmartScan to perform the following tasks:
• Display Values in volume format.
• Display Values as a total accumulative value for flow.
• Calculate volume for different tank types.
• Calculate flow measurements for custom flumes.
• Calculate results in alternative measurement units.
• Adjust results when there is interference from a conical tank ending.
• Allow compensation of different types of gas.
Press / Action Display Description
Connect SmartSonic to power supply See Wiring Section
The SmartSonic takes several seconds to
warm-up. During this time various characters
will turn on and off, and the Tank Graphic will
cycle
and simultaneously
This is the password display
and
Use to enter the password (716) in place of
(000). BACK and NEXT will change the vlue of
the digit (0-9). ENT steps to the next digit; ESC
steps to the previous digit.
Single Sensor (only available option).
Flashes for 5
seconds, then is
displayed
Is now displayed
Flashes for 5
seconds Pr 0 is now displayed.
or
Use BACK or NEXT to scroll through the other
menu options (described later in this section)
NOTE: Press ESC once to return to the Main Menu. Press ESC a second time to return to the normal operating mode.