SARGENT Profile Series v.G1.5 Exit Devices - Manual

FCC Statement
15.21 Information to User
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Data Transfer Device (DTD)
Specifications/Requirements:
Mechanical: PC Connection:
3 7 /
8
” W x 5 3 /
4
” L x 1 1 /
2
” D USB Port (v1.1 or v2.0) Only
Environmental: Software Compatibility:
Environment: Store Indoors. SoloPlus TM v1.0 (or higher)
Do not get wet. DTD Printer Utility (available with SoloPlus TM v1.0 or
Temperature Tolerance: 32º F to 120º F (0º – 49ºC) higher)
Electrical: Firmware Version:
Operating Voltage: 6V (Four AA Batteries) This manual applies to firmware version 00.44
Software Compatibility
The DTD supports two modes of operation. When using the DTD as a transfer device in DTD Mode, SoloPlus TM version 1.0 (or
higher) is required. When using the DTD to retrieve Infrared Printer logs you must use the DTD Printer Utility, which is available on
the software installation CD with SoloPlus
TM version 1.0 (or higher).
The included software installation CD supports the DTD and contains the required USB drivers.
Packing List
(1) Data Transfer Device
(1) Installation Instructions
(1) USB Cable
(4) AA Batteries (already installed – see Battery Installation Section before use)
(1) Software Installation CD
Important Notes
● If you update the DTD firmware (refer to Section 5) some portions of this manual may no longer apply. Please contact the
manufacturer for the latest version of this manual.
● You can access an electronic copy of this manual from the DTD Printer Utility, by pressing the F1 key when the program is
open.
Corbin Russwin # FM 296; Sargent # A7973B Rev. 1.1 Page 1 of 26