SARGENT Profile Series v.G1.5 Exit Devices - Manual (Page 6)

Section 2: DTD Setup Data Transfer Device Operating Instructions
Section 2: DTD Setup
2.1 Connecting the Data Transfer Device to a PC USB port
To connect the DTD to your PC USB port, use the USB cable provided with your DTD. First plug the small end (Type Mini-B) of the
6-foot USB cable into USB connector on the top of the DTD. Then plug the large end (Type A) of the 6-foot USB cable into your PC's
USB port. Figure 2 below illustrates this connection.
Page 6 of 26 Corbin Russwin # FM 296; Sargent # A7973B Rev. 1.1
Important Note:
Do not connect more than one DTD to your PC at a time.
Figure 2: Connecting the DTD to PC USB Port