SARGENT Profile Series v.G1.5 Exit Devices - Manual (Page 20)

Section 4: Printer Mode Data Transfer Device Operating Instructions
Section 4: Printer Mode
4.1 SET PRINTER MODE
To configure your DTD to operate in Printer Mode (from DTD Mode), go to the STATUS MENU as described in section 3.3, then
select the SET MODE option as discussed in section 3.3.3. When the screen below appears, move the cursor down to the SET
PRINTER MODE option and press ENTER. The = symbol will move down to the new setting, as shown. To return to the Start-Up
Screen press the * key.
4.2 Printer Mode Main Menu
When the DTD is first powered-up the the Start-up Screen is displayed (refer to section 1.3). To access the Printer Mode menu
system press the ENTER key, which is the number 5 key in the center (refer to figure 1 on page 3).
Next you are presented with three main sub-menu selections: INFRARED CAPTURE, SEARCH DOORS and STATUS. The
INFRARED CAPTURE option is used to capture data sent from the controller. The SEARCH DOORS menu option allows you to
search through previously captured door data and view the information on the display. The STATUS menu contains information about
the DTD, as well as an option to change the operating mode. These menu options are described in more detail in later sections.
To navigate through the menu system, press the down arrow, which is the number 8 key in the lower center or the up arrow, which is
the number 2 key in the upper center. The blinking cursor on the left of the DTD display moves up and down next to the various
options. To select and option press the ENTER key. To move back to a previous menu press the left arrow, which is the number 4 key
on the left center.
Page 20 of 26 Corbin Russwin # FM 296; Sargent # A7973B Rev. 1.1
Note: If at any time you want to return to the Start-up Screen press the * key in the lower left corner. Also
pressing the left arrow brings you back to the previous menu.