Prefix 80 series exit device, Exit device plug-in connector installation 8 – SARGENT 57 - Delayed Egress User Manual
Page 14
Pigtail harness
assembly with
8-pin connector
4
1
2
57- 80 Series Rail
with 8-pin connector
3
Electric Hinge with
8-pin hinge connector
Raceway harness with
8 & 4-pin connectors.
The 4-pin connectors are not
used here.
Note: No field rail cutoff allowed. Exit device must be ordered for specific door width.
1. Mount exit device per instruction sheet provided.
To insure trouble free operation, check that the push rail can be fully depressed. On
vertical rod exit devices, check that the latch bolts do not go into hold back position
until the push rail is fully depressed.
2. Plug rail connector into raceway connector then feed through 1” hole in door.
Install rail mounting bracket with two screws supplied. Install rail end cap.
3. Plug raceway connector into electric hinge connector then feed through door prep.
Mount electric hinge to door.
4. Go to (a) if wiring now. Go to (b) if wiring is to be done later.
a. Refer to sections 8 and 9. Wire loose frame side wires to loose wires on
pigtail harness as required using connectors allowed by local code. Plug pigtail
harness connector into electric hinge connector. Feed harnesses through frame
prep and mount electric hinge. Refer to operating instructions in section 10.
Apply power and test exit device.
b. Plug pigtail harness connector into electric hinge connector. Feed harnesses
through frame prep and mount electric hinge.
Mounting
bracket
1” dia. hole
in door
Screw
locations
Ring terminal
(from harness)
Exit Device Plug-in Connector Installation
8
Insert bracket mounting screw through *ground
ring terminal. Fasten mounting bracket with
mounting bracket screws (ring terminal).
*Ring terminal must be grounded as indicated.
!
14 1-800-810-WIRE • www.sargentlock.com • A7743C
Copyright © 2013, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
04/15/13
57- Prefix 80 Series Exit Device
- FM8700 Surface Vertical Rod Exit Device PR8700 Center & Top Latch Surface Vertical Rods for Pair of Doors PP8700 Center & Top Latch Surface Vertical Rods for Pair of Doors HC8700 Hurricane Code Surface Vertical Rod Exit Device NB8700 Top Latch Surface Vertical Rod 8700 Surface Vertical Rod Exit Device SP8600 Center & Top Latch Concealed Vertical Rods PR8600 Center & Top Latch Concealed Vertical Rods PP8600 Center & Top Latch Concealed Vertical Rods LR8600 Low Profile Center & Top Latch Concealed Vertical Rod Exit Devices LP8600 Low Profile Center & Top Latch Concealed Vertical Rod Exit Devices NB-WD8600 Concealed Vertical Rod Exit Device for Wood Doors WD8600 Concealed Vertical Rod Exit Device for Wood Doors NB-MD8600 Concealed Vertical Rod Exit Device for Metal Doors MD8600 Concealed Vertical Rod Exit Device for Metal Doors NB-MD8400 Series Narrow Style Concealed Vertical Rod MD8400 Series Narrow Style Concealed Vertical Rod LS8600 Low Profile Center & Top Latch Concealed Vertical Rods WS8900 Mortise Lock 8900 Mortise Lock Exit Device 8300 8888 Reversible Rim Exit Device 8800 Rim Exit Device 8500 Narrow Design Rim Exit Device HC8800 Rim Exit Device