SARGENT 57 - Delayed Egress - Manual (Page 18)

Armed Mode (Delayed Egress)
Green LED
Red LED
Momentary Egress Mode
Operating Instructions
There are three modes of operation: Armed (Delayed Egress), Momentary Egress and Maintained Egress.
1. Apply power to the System; horn will sound for one second
2. Both LEDs will flash RED, then both LEDs will flash GREEN
3. Green (default) or Red LED on Electroguard™ insert will illuminate
(See DIP switch settings section 7)
4. Rail assembly is armed. Latchbolt cannot be retracted by de-
pressing the push rail for immediate egress. If rail is depressed for
(min.) one second, alarm will sound.
5. If any of above sequence fails to function, the unit is not armed.
See: Troubleshooting section
1. Rotate key counter-clockwise to 2nd click and return key to
center position (key out)
2. Red (Default) or Green LED flashes on insert for a factory preset
time of 5 seconds. (For other time selections and LED color, see
Dip Switch Settings section 7.) The rail assembly will disarm itself
and de-energize the external magnet for this time period allowing
for momentary egress.
3. After the factory preset time of 5 seconds, delay expires. Rail
assembly re-arms itself and the external magnet is re-energized.
4. Unit is then in Delayed Egress Mode (or Power Up State)
*Depends on handing
10
These modes are set by fully inserting a valid key and rotating it in either a clockwise or counter-clockwise
direction until there is a click (detent).
Note that a second click must be engaged in order to set momentary egress.
To remove the key, it must be returned to its original center position.
Center (key out)
Maintained (Disarmed)
Delayed Egress (Armed)
1 st click
Momentary Egress
2 nd click
• Both insert LEDs illuminate "red" for 2 seconds while concurrently sounding buzzer for 500ms.
• Both insert LEDs illuminate "green" for 2 seconds (no buzzer)
• The (4) diagnostic LEDS on bottom of module illuminate for 2 seconds.
• Insert LED illuminates to the switch position (armed or not armed).
Note: Power-up sequence is as follows:
18 1-800-810-WIRE • www.sargentlock.com • A7743C
Copyright © 2013, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
04/15/13
57- Prefix 80 Series Exit Device