Amico SSM Monitor Arms (Side to Side) - Manual (Page 12)

9 Amico Accessories
Section 3: Monitor Installation
Mounting adapter
Monitor dependant hardware
Monitor
Front of the
mounting adapter
(Figure 1) (Figure 2)
Mounting shelf
1. First install the mounting adapter to the device (Please refer to the adapter installation manual provided with the
adapter)(Figure 1 on previous page).
2. Loosen the plastic screws on the bottom side of the mounting shelf. Pull down on the plunger lock at the bottom of
the mounting shelf and twist it to keep it open. Slide the adapter laterally onto the mounting shelf until the plunger
aligns with the clearance hole at the front of the mounting adapter.
(Figure 3)
3. Release the plunger and tighten the plastic screws by hand (Figure 4) .
Plunger Lock
Plastic Screws
Front of the shelf
5’’ mounting shelf is shown above
(Figure 4)
Plunger pulled
Plunger released
Mounting shelf
(Figure 3)
WARNING: Ensure the mounting shelf is securely locked and horizontal to prevent the monitor from sliding and
falling. (See Page 16)
WARNING: On the bottom of the mounting shelf there is a plunger that secures the shelf to the mounting
adapter. Simply pull down on the plunger, align the adapter plate with the shelf and release the plunger once
positioned over the clearance hole
(Figure 3).
NOTE: The plunger can be locked in the open position by pulling and twisting it.
Monitor Shelf: 3” Top/Back Mount, 5” Top/ Back Mount and VESA