Amico SSM Monitor Arms (Side to Side) - Manual (Page 23)

www.amico.com 20
Section 4: Adjustments
(Figure 1)
Cable Management: MRS Rail Cover
1. Guide the cables into the center of the MRS rail, keep cables off the two sides of the MRS rail. (Figure 2)
2. Guide the MRS rail cable cover into the channel over the cable. Ensuring no cable is pinched between the rail and
the cover. Safely trim off any excess MRS cover after installation.
(Figure 2)
NOTE: A Cable guide is provided to facilitate routing of cables along the bottom of the arm.
1. Route cables between the openings and snap them into the cable guide. Larger cables may require the cable
guide be pried apart, in that case, take care not to damage the cable guide. Leave some extra cable loose at
the front and rear of the arm to prevent cable binding, connector damage, or cable guide damage (Figure 1).
Cable Cover Bottom of the SSM Arm
Direction to slide
MRS Rail Cover
Cable Management: SSM