Dell S320wi Projector - Manual (Page 60)

a Computer/Laptop with a 120 Hz signal output quad-buffered
graphics card.
b "Active" 3D glasses with DLP Link™.
c 3D content. See "Note 4".
d 3D Player. (Example: Stereoscopic Player...)
2. Enable the 3D function when it satisfies any of the below-mentioned
conditions:
a Computer/Laptop with graphics card, capable of outputting at
120 Hz signal via VGA or HDMI cable.
b Input a suite of 3D content via Video and S-Video.
3. "3D Display" selection will only be enabled in the "Display Settings of
the Advanced Settings" menu when the projector detects either of
the inputs mentioned above.
4. 3D support and refresh rate are as below:
a VGA/HDMI 1280 x 720, 1024 x 768, and 800 x 600 at 120 Hz
b Composite/S-Video at 60 Hz
c Component 480i and 576i
5. The recommended VGA signal for laptop is Single-mode output
(Dual mode is not recommended).
3D F ORMAT —Allows you to select the 3D format. Options are: Side By Side,
Side By Side Full, Frame Sequential, Field Sequential, Top/Bottom, and
Top/Bottom Full.
3D S YNC I NVERT —If you see a discrete or overlapping image while
wearing DLP 3D goggles, you may need to execute 'Invert' to get best
match of left/right image sequence to get the correct image. (For DLP
3D goggles)
P ROJECTOR S ETTINGS —Select and press to activate projector settings. The
projector settings menu provides the following options:
Using Your Projector 60