Thermcraft XST-3-0-36-3V - Manual (Page 240)

Configuration Installation and Operation Handbook
6-10 2416 Controller
The following parameters apply if the standard 8-segment programmer is to be configured.
PROG Programmer configuration Values Meaning
PtyP Programmer type nonE Programmer disabled ( factory setting )
1 8-segment programmer enabled
HbAc Holdback SEG
ProG Holdback is individually selectable in
each segment.
Holdback is applied across the whole
Program.
Pwr.F Power fail recovery cont Continue from last setpoint (SP)
rmP.b Ramp from PV to SP at last ramp rate
rSEt Reset the program
Srvo Starting setpoint of a to.PV From the Process Value (PV)
program (Servo point) to.SP From the setpoint
The following parameters apply if a 16-segment programmer is to be configured.
PROG Programmer configuration Values Meaning
PtyP Programmer type nonE Programmer disabled
1 Single program
4 Four programs
HbAc Holdback SEG
ProG Holdback is individually selectable in
each segment.
Holdback is applied across the whole
Program.
Pwr.F Power fail recovery cont Continue from last setpoint (SP)
rmP.b Ramp from PV to SP at last ramp rate
rSEt Reset the program
Srvo Starting setpoint of a to.PV From the Process Value (PV)
program (Servo point) to.SP From the setpoint
out Programmable event
outputs no
YES
Disabled
Enabled
SYNC Synchronisation of programs
of several programmers
Not usable in Model 2416
no
YES
Disabled
Enabled
Select ‘
no’
Name Description Values Meaning
HA Comms 1 module config
id Identity of the module
installed cmS EIA-232, or 2-wire EIA-485, or 4-wire
EIA-485 comms
PDS PDSIO retransmission
PDS.i PDSIO input