Two Brothers Racing Can-Am Outlander 1000R - Manual

1. Make sure the ATV is completely cool before starting
the installation. Make sure the ATV is secure on a level
surface and the parking brake is set.
2. Remove muffler.
3. Remove grommet and sleeve from OEM muffler and
insert into TBR muffler mount.
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
Installation Instructions
4. Attach slip-on tube to TBR muffler using the provided 4
6x20mm bolts and lock washers with X-ring. Leave loose
for now.
5. Attach muffler mounting bracket (supplied) to rear OEM
muffler mounting hole using the supplied 8x60mm bolt
and nut as shown.
6. Loosely install muffler assembly and attach to mounting
bracket using the OEM bolt and nut for alignment. After
exhaust is aligned tighten one X-ring bolt to secure slip-
tube in place.
7. Remove muffler assembly and tighten the remaining
X-ring bolts and re-install and secure in place using OEM
nut and bolt.
8. Tighten Barrel clamp.
9. Double check your work and make sure all bolts are
tightened and the exhaust is aligned correctly.
10. Before you run the ATV, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Run the
ATV and enjoy. It is normal for some white smoke to
appear the first time you start the ATV. This is packing/
manufacturing oil from inside the pipe burning off.
Check for gaps or leaks. If you find a leak, a little high
temperature silicon sealant should fix it. After 50 to 100
miles, recheck all fasteners for tightness.
2012 Can-am
Outlander 1000R
V.A.L.E.™ Slip-on Exhaust System with M-7 Aluminum Canister
Part # 005-3130406V
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
instructions first before starting installation. Make sure the motorcycle and
exhaust system are completely cool before starting the installation. Be sure
to save all stock components for possible use later.
**This product has not been tested with all available accessories and some
items may cause excessive heat. Excessive heat may cause damage to your
vehicle. Two Brothers Racing will not be responsible for damaged parts.