Salter Brecknell WB-521 Series - Manual (Page 36)

34 SBI521 Service Manual
3.9.1 Enable Accumulation
To make the accumulation function be available the CONFIG-FUNC-ACCUMU
parameter should be set to MANUAL or AUTO.
Manual Accumulation
When CONFIG-FUNC-ACCUMU is set to MANUAL, the stable and positive displayed
net weight must be larger than the USER-OTHER-NLD.RNG setting.
Piece or percentage can be accumulated by a long press of the [TOTAL] key. The
indicator will display accumulation times first and then display total of number.
Auto Accumulation
When CONFIG-FUNC-ACCUMU is set to AUTO, the stable and positive displayed net
weight must be larger than the USER-OTHER-NLD.RNG setting.
Piece or percentage can be accumulated automatically. The indicator will display
accumulation times first and then display total number of accumulations.
View Total
When the displayed number is zero, press the [TOTAL] key for 3 seconds. The
indicator will display accumulation times first and then display total of number.
NOTE:
l
ZERO only be active when scale is stable and weight is in SAZSM setting
range.
l
TARE only be active when the scale is stable.
l
When the TARE weight or ZERO weight is cleared, the indicator will display
the GROSS mode.
l
NET weight is displayed when a TARE weight is entered.
3.10 Display and Set Time
1. Enter the Setup Mode by pressing the [SETUP] key more than 3 seconds.
2. Use the [PRINT] or [N/G] key to select the MISC menu.
3. Press [TARE] to select the MISC menu.
4. Press the [PRINT] key to scroll to the TIME parameter.
5. Press [TARE] to display current time.
NOTE: Be sure to remove the accumulated load to avoid duplicating an accumulation.
The weight on the scale must be smaller than the setting at USER-OTHER-NLD.RNG
to continue.
NOTE: Be sure to remove the accumulated load to avoid duplicating an accumulation.
The weight on the scale must be smaller than the setting at USER-OTHER-NLD.RNG
to continue.