Dynojet 250i: Pit Installation Guide - Manual (Page 34)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Eddy Current Brake
2-12
4 Place the ends of a nylon loop strap through the lifting eyes on either side of the
brake and hook onto the shaft.
5 Using a forklift, lift the eddy current brake from the crate and place the brake in
the pit near the drum module making sure not to hit the driveline assembly.
6 Record the eddy current brake number on the inside cover of this manual.
# RECORD
Be sure you record the eddy current brake number on the inside cover of this
manual.
Figure 2-7: Record the Eddy Current Brake Number
eddy current brake number
lifting eye