Dynojet 250i: Pit Installation Guide - Manual (Page 97)

A C C E S S O R I E S
Wheel Clamp
Version 4 In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
3-19
4 Bring the wheel clamp cable (three-pin connector) from the cable track over to
the wheel clamp. This cable was routed on page 2-37.
5 Install the wheel clamp cable strain relief to the side of the wheel clamp.
6 Plug the wheel clamp cable into the connector on the wheel clamp motor.
7 Replace the wheel clamp cover.
Figure 3-21: Secure the Strain Relief and Cable
PD181
wheel clamp cable strain relief
cable track
wheel clamp
motor connector