Satellite High Rise - Manual (Page 8)

PN 20930 REV A Page 7
6. FASTEN CORNER GUSSETS.
FASTEN #28 GUSSETS UNDER REAR CORNER ANGLES. FASTEN WITH #38 RIVETS AND #48
WASHERS AS SHOWN. REPEAT ON OPPOSITE CORNER.
7. TIGHTEN ALL BOLTS AND NUTS IN ANGLES TO FLOOR USING THE 7/16” SOCKET AND
WRENCH.
8. INSTALL TANK AND TOILET SEAT IN REAR OF TOILET.
SLIDE #18 TANK INTO BACK OF TOILET. FASTEN #16 TOILET SEAT TO TANK. TRANSFER DRILL
THROUGH HOLES IN PANELS (2 PER PANEL) THROUGH #18 TANK. FASTEN PANELS TO TANK
WITH #41 RIVETS AND #48 WASHERS. RIVETS ON OUTSIDE OF TOILET AND WASHERS ON THE
INSIDE OF THE TANK.
INSTALL THE #20 VENT PIPE. SLIDE VENT PIPE BETWEEN GUSSET AND ANGLES IN TOP REAR
LEFT CORNER OF UNIT. SLIDE VENT PIPE IN HOLE IN TANK. TOP OF VENT PIPE SHOULD BE
4.50” FROM TOP SURFACE OF HORIZONTAL ANGLES. FASTEN WITH VENT PIPE TO TANK WITH
#42 SCREW, USING A 3/8” NUT DRIVER BIT AND DRILL.