Satellite Taurus - Manual (Page 8)

PN# 18680 REV. G 8 5-17-11
19. Insert the hairpin rod (See fig. A) in the toilet paper holder. Drill (4) 3/16” holes through the
toilet paper holder and side wall. The right side of the paper holder should be approximately
centered in the front grab area. (See fig. A) The top of the paper holder should be flush with
the wall rib just below the signage recess. (See fig. B) Fasten the toilet paper holder with
Rivets, #68 AAL #11054 (4) and Washer, 3/16” #11315 (4). Washers are located on the
inside of the unit.
A B
20. Position the door spring guides to the recess in the jamb. Using the provided hole in the
spring guide, drill (2) 3/16” holes through first layer of the jamb only. Fasten the top and
bottom door spring guide by stretching the cable from the door to the jamb with expanding
Rivet #18755 (1) on each door spring guide. Check to determine if door catches on roof, by
opening door 180
° and allowing closing. If roof interferes, remove interfering roof material.