FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual User Manual
Page 171
4 – Appendices
NET SatisFAXtion 8.7 Manual
171
where a user does not want to send a fax slower than 12000 baud, but the
modem only supports 9600 baud as its highest baud rate. Error type:
NON_RETRYABLE
.
1127 Remote device does not support fax:
The remote modem indicated it
is not capable of faxing. Error type:
NON_RETRYABLE
.
1128 Invalid response to
ECM block: The valid responses from the remote
following the transmission of an ECM block should be RNR, PPR or MCF. Some
other signal was received. Error type:
RETRYABLE
.
1129 Remote fax not ready for next page:
The T5 timeout (60 seconds ± 5
seconds) occurred while exchanging RR and RNR signals for an ECM send. Er-
ror type:
RETRYABLE
.
1130 No response to
ECM end-of-page: The sender had received a RNR at
which time it responds with an RR signal. It then expects the remote to send ei-
ther a RNR or an MCF within T4 seconds. There was no response received. Er-
ror type:
RETRYABLE
.
1131 No more baud rates to try:
After a 4th ppr signal is received, a CTC
signal is sent so as to step down the baud to the next configured baud rate. All
configured baud rates have been exhausted. Error type:
RETRYABLE
.
1132 No response to CTC:
No response after CTC. Error type:
RETRYABLE
.
1133 Invalid response to CTC:
The expected signal after CTC is CTR. Some
other signal was received. Error type:
RETRYABLE
.
1134 Invalid response after
ECM block: After receiving an ECM block, the
expected signals are PPS, CTC or RR. Some other signal was received. Error
type:
NON_RETRYABLE
.
1135 Unexpected DCN:
During receive, a DCN signal was received at a point
where it is not expected. This most commonly occurs under ECM. For non-ECM
faxes, a DCN received after page data does not generate an error since some
fax machines don’t bother with a post page signal on the last page. Error type:
NON_RETRYABLE
.
1136 Call hung up before fax was complete:
The modem returned a NO
CARRIER while sending. Error type:
RETRYABLE
.
1137 The sender specified a modulation that is not supported:
The DCS
has an invalid baud rate/modulation specified. Error type:
NON_RETRYABLE
.
1138 ECM required for V.34: The remote does not support error correction
mode which is required for the V.34 connection that was established. Error
type:
NON_RETRYABLE
.
1139 Unexpected V.34 end-of-transmission:
Remote fax sent an unexpect-
ed V.34 modulation end of transmission indication. Error type:
RETRYABLE
.
1140 V.34 did not step down baud after fourth PPR:
We received the 4th
PPR when sending a fax using V.34 modulation and the receiver did not step
down the baud rate. Error type:
NON_RETRYABLE
.