Cub Cadet Fun Runner - Manual (Page 31)

4-15
MOTOR CONTACTOR REMOVAL & INSTALLATION
STEP DETAILS
Make sure vehicle is safe. Switch off and key removed.
Parking brake set.
Remove canopy assembly (if installed).
Remove utility bed (if installed). Remove 4 Phillips head screws.
Lift bed off and set aside.
Turn off master power switch. Located behind seat.
Remove rear body section (Figure 4-18). 4 screws at front below seat.
Two screws each side beside seat.
Two screws below rear of seat (over battery).
4 screws around top of storage compartment.
Lift rear of section and work it free. May have to
cut one or more electric tie wraps so section can
be lifted off without placing strain on charger
cable and plug.
Unplug charger power cable (Figure 4-19). Inside front of rear body section.
Press button in side of plug and disconnect.
Disconnect activation wire terminals
(Figure 4-20). Remove nuts and note location of wires.
Disconnect cables from controller and to motor
(Figure 4-21). Slide terminal covers off.
Disconnect cable from controller then cable to
motor.
Remove contactor (Figure 4-22). Note: two nuts will come loose and fall when
screws are removed.
Remove two common point screws on outside
of frame.
Slide contactor off the mounting screws to
inside of frame.
Connect cables to motor and from controller. Connect cable to motor then cable from
controller.
Slide terminal covers onto terminals.
Connect activation wire terminals. In the same positions they were before (red
lead near power cable from controller)