Step details – Cub Cadet Fun Runner User Manual
Page 57
Advertising
4-41
ACCELERATOR POT (THROTTLE SENSOR) REMOVAL
& INSTALLATION
STEP
DETAILS
Make sure vehicle is safe.
Switch off and key removed.
Set parking brake.
Remove pot (Figure 4-54).
Two screws – need 5/16” socket wrench or
common point screwdriver.
Disconnect pot (Figure 4-55).
From wiring harness.
Install new pot.
Mount with two screws.
Plug into wiring harness.
Make sure any excess wire is tie wrapped out of
the way.
Test new pot.
Check vehicle acceleration and speed are
normal.
Advertising