Brake shaft assembly – Cub Cadet Z-Force S Series User Manual

Page 18

Advertising
background image

Z-Force-S

12

Brake shaft assembly

To remove/replace the brake shaft:

1.

Remove the cutting deck by following the proce-
dures described in Chapter 8: Cutting Decks and
Lift shaft.

2.

Lift and safely support the rear of the mower.

3.

If the parking brake is set, release it.

4.

Disconnect the brake springs. See Figure 3.11.

5.

Disconnect the link that runs from the idler bracket
to the brake shaft by removing the cotter pin.
See Figure 3.12.

6.

Disconnect the adjustable drive links from the pivot
arms by removing the bow tie clips at the ferrule end
of the link. See Figure 3.13.

Figure 3.11

Brake springs

Figure 3.12

Link

Cotter pin

Figure 3.13

bow tie clip

Adjustable drive

links

Advertising