Futaba 3PJS User Manual

Page 36

Advertising

Direct Mode Functions

5. To adjust the brake side

(back side), push the throttle
trigger all the way to the
brake side and adjust the per-
centage with the + and - keys.
However, when using an FET
amp, set the percent-
age to 100%.

- 2 times

ATL Trim

During operation, the brake side servo can be adjusted with the ATL trim. When
adjusting the servo with throttle ATV, ATL must be set for maximum travel in ad-
vance.

Setting range; 0~120%

- Return to the initial value (100%) by pressing the + and - keys
simultaneously for about one second.

6. At the end of adjustment,

press the DIRECT key twice.
(Returns to the initial screen.)

Maximum travel

The

throttle

ATV

function

determines

the

maximum

servo

travel.

However,

when

the

following functions are adjusted, the maximum travel may exceed the limit set by the
ATV. Be sure to inspect your linkage installation after any adjustment is made.

- Throttle subtrim
- Programming (When throttle is set to slave side)
- Idle-up
- Throttle preset

Note

When the travel is insufficient even when ATV is increased up to 120%, it can be
increased somewhat by using programmable mixing.
(See page 84.)

Blink

To adjust the brake side (back side), push the throttle trigger all the way to the

brake side and adjust the percentage with the + and - keys. However,
when using an FET amp, set the percentage to 100%.

DIRECT

ST.EXP

M.SEL

SETUP

RESET

SELECT

DOWN

TH.EXP

ATV

CUSTOM