Futaba 3PJS - Manual (Page 61)

61
SELECT Mode Functions
Traction Control
Sudden trigger operation on a slippery track not
only causes the wheels to spin, but also prevents
smooth acceleration. Smooth and pleasant control
is possible and battery consumption can be mini-
mized by setting the traction control function.
With TRAC
Smooth, fast starting is possible
Without TRAC
Wheels slip and car
does not move
Operation
The traction control function prevents the drive wheels from spinning even if the
trigger is operated more than necessary by providing a delay when the throttle servo
(amp) operates. This delay function is not performed when the trigger is released and
during braking.
- Low side traction control
Used to apply a delay from the neutral position to the set point (delay point).
- High side traction control
Used to apply a delay at the high side from the set point.
1. Call the traction control func-
tion set-up screen by press-
ing the DOWN key four times
at the initial screen.
- 4 times
2. Activate the traction control
function by pressing the + or -
key.
3. (Delay amount setting)
Press the SELECT key once.
4. Adjust the delay amount with
the + or - key,.
If the delay is too large, op-
eration will be delayed.
Setting range: 0~100%
- Return to the initial value (0%) by
pressing the + and - keys simulta-
neously for about one second.
Setting Example
Adjust within the entire range (0~100%) according to the conditions.
Blink
Blink
Blink
DIRECT ST.EXP M.SEL UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM