IOTA I-160 User Manual

I-160, Important safeguards, Instruction manual

Advertising

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

CAUTION – To prevent electrical shock, do not mate unit connector until installation is complete and A.C. power

is supplied to the unit.

CAUTION – This fixture provides more than one power supply output source. To reduce the risk of electrical

shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by disconnect-

ing the unit connector.

CAUTION – The integral, high temperature Ni-Cad battery is replaceable. To replace the battery, disconnect the

unit connector and remove both switched and unswitched A.C. power to the fixture. Remove the lid screw and

open the lid to expose the battery. Unplug the battery connector and replace with part number 44203-412 (14.4V

Ni-Cad battery only). Recycle or dispose of the used nickel-cadmium battery properly.

DO NOT USE OUTDOORS. The I-160 is for use with grounded, UL Listed, damp location rated, indoor fixtures.

Not for use in heated air outlets or hazardous locations.

5. The

I-160 requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the unused A.C.

lead.

6. When the

I-160 is installed on the same branch circuit, refer to Illustration 3, Figures A and B for input wiring. When

installed on separate branch circuits, refer to Illustration 3, Figures C and D for input wiring. Per NEC, the

I-160 and

A.C. ballast must be on the same panel board.

7. Do not mount near gas or electric heaters.
8. The

I-160 should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

9. The

I-160 mounts on top of the fixture or adjacent to the fixture on an optional T-bar mounting bracket.

10. The

I-160 will cold strike and operate one 2

′–4′ 24W-95W T5, one 17W-59W T8 lamps, one 25W to 50W long com-

pact, one 18W-70W 4-pin compact lamp, one or two 17W 2

′ T8 or one or two 18W 4-pin compact fluorescent lamp.

11.

The

I-160 operates lamps as follows:

One or two 2

′–4′ T8 lamps, or one or two 4-pin compact fluorescent lamps, or one 8′ select linear lamp for 90 minutes.

12. Suitable for use in damp locations.
13. For use in 0° C minimum, 50° C maximum ambient temperatures.
14.

The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition,

void

warranty, and result in non-compliance with UL specifications.

15. Do not use this equipment for other than intended use.
16. Install in accordance with the National Electrical Code and local regulations.
17. Installation and servicing should be performed by qualified personnel.
18. Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility before

final installation.

SAVE THESE INSTRUCTIONS

I-160

SERIES AC

EmERgENCy

LIghTINg EqUIPmENT

INSTRUCTION MANUAL

P.O. BOX 11846 TUCSON, AZ 85734

(520) 294-3292 • FAX (520) 741-2837

www.iotaengineering.com

Advertising