ATEIS IDA8C - Manual (Page 56)

Ateis Studio 56
© 2012 ATEÏS
channel audio and data network over CAT5 or fiber optic. Each IDA8S expands the IDA8 System with an
additional 8 outputs, 2 additional security microphone consoles PSS AS and security programmable
switching contacts.
The Network cards that comes with the unit provides a redundant 48 channels audio and data
connection, AteÏs-Net, between one controller and a maximum of 32 IDA8SX Slave units in one rack
system.
4.1.4.2 Front Panel
System Fault LED
This LED lights on when a system fault fault is detected.
G.Fault LED
This LED lights on when a global fault is detected.
Bypass Mode LED
To indicate IDA8C is in bypass mode or not.
Bypass Monitoring LED
Show the monitoring function is enabled or not. This LED lights on if monitoring of IDA8 is disabled
by user.
Global EVAC LED
To indicate system is in EVAC paging state or not. This LED lights on if any IDA8 device over Ateis
Net do an EVAC paging. See the topic of Network Paging Component to learn more about how to
config a EVAC paging.
Zone EVAC LEDs
To show the audio channel is in EVAC paging or not. Each LED is correspond to a output channel of
Network Paging component, for example, 1st LED is for pin M1, 2nd LED for pin M2 and so on.
Power LED
This LED lights on when IDA8S is power on.
Network LED
Show the status of Ateis Net. This LED lights on if more than two deployed IDA8 devices in Ateis
Net.
Zone Fault LEDs