Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 31)

S e t t i n g t h e R i b b o n
If you are using thermal direct supplies, do not load a ribbon and set the ribbon option to
No
. If you are using thermal transfer supplies, load a ribbon and set the ribbon option to
Yes . If you are using high energy supplies (TUFF-MARK®), load a high energy ribbon and
set the ribbon option to High Energy. See " Using a High Energy Ribbon " for more
information.
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow
these steps.
1. Press  or  until you see Ribbon.
CHANGE BACK
Yes
Ribbon →
SUPPLY
2.
Press CHANGE to highlight the ribbon options. The current setting is shown.
3. Press  or  to scroll through the ribbon options.
SET CANCEL
Yes →
Ribbon
SUPPLY
4. When you see the ribbon option you need, press SET to save the change. Press
CANCEL
to leave the ribbon option unchanged.
5. Press BACK until you return to the Home/Online screen.
Yes
CHANGE BACK
SUPPLY
Ribbon →
Note:
If you choose Yes , install a ribbon before printing. If you choose No, do not
install a ribbon before printing. If you choose High Energy the printer displays
the warning message, “High Energy ribbon can damage the printhead”. Press
ENTER
to clear the warning.
Setting Supply Options 4-3