Dataprobe iBoot-WiFi Quick Start - Manual

Important Safety Instructions
When using this product, basic safety precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and labels marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
4. Do not use this product in an outdoor environment or near water, for example, near a bath tub, wash bowl, kitchen
sink, or laundry tub, in a wet basement, or near a swimming pool.
5. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the
product.
6. Slots and openings in this product and the back or bottom are provided for ventilation to protect it from overheating;
these openings must not be blocked or covered. The openings should never be blocked by placing the product on the
bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register.
This product should not be placed in a built‐in installation unless proper ventilation is provided.
7. This product should be operated only from the type of power source indicated on the marking label. If you are not sure
of the type of power supply to your home, consult your dealer or local power company.
8. This product is equipped with a three wire grounding type plug, a plug having a third (grounding) pin. This plug will only
fit into a grounding type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet,
contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding type plug.
Do not use a 3‐to‐2 prong adapter at the receptacle; use of this type adapter may result in risk of electrical shock and/or
damage to this product.
9. Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons
walking on it.
10. Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
11. Never push objects of any kind into this product through slots as they may touch dangerous voltage points or short out
parts that could result in a risk of fire or electrical shock. Never spill liquid of any kind on the product.
12. To reduce the risk of electrical shock, do not disassemble this product, but take it to a qualified serviceman when some
service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks.
Incorrect re‐assembly can cause electric shock when the appliance is subsequently used.
13. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following
conditions:
a) When the power supply cord or plug is damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating instructions. Adjust only those controls that
are covered by the operating instructions because improper adjustment of other controls may result in damage
and will often require extensive work by a qualified technician to restore the product to normal operation.
e) If the product has been dropped or has been damaged.
f) If the product exhibits a distinct change in performance.
14. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric
shock from lightning.
15. Do not use the telephone to report a gas leak in the vicinity of the leak.
16. Do not exceed the maximum output rating of the auxiliary power receptacle.
What’s Included

iBoot‐WiFi Unit

Quick Start Guide
Available Online
dataprobe.com/support_iboot‐wifi.html

Complete Product Manual

Setup and Operation Videos

Latest iBoot‐WiFi Firmware

Software Developer Tools
Product Registration
dataprobe.com/product‐registration.html

Get Important Safety Notifications

Receive Firmware Release Notices

Special offers only available to registered users
Orientation
LEDs and Pushbuttons
Outlet LED
Red On Outlet Power On.
On with momentary Off (1.2 /.1) Power On – Cycle in Progress
Slow Flash (.5s) Reset to Factory Defaults in Progress
Off with Momentary On (1.2 /.1) Power Off – Reboot in Progress
Off Outlet Power Off
Network LED
Blu
e
On Network Connected
On with momentary Off (1.2 /.1) Micro Access Point Only Mode
Slow Flash (.5s) Network Connection in Progress
Fast Flash (.1s) Network Connection Attempt Failed
Off Unit not receiving power
WPS
Pushbutton Push and Hold 7 sec. Initiate WiFi Protected Setup (WPS)
Reset
Pushbutton Momentary Press Restart iBoot‐WiFi
Press and Hold 10 Seconds Reset Factory Default
WiFi
Quick Start Guide
Network LED Outlet LED
WPS
Pushbutton Reset
Pushbutton
Power Outlet
12 Amps Max