Gasboy CFN Series NBS - Manual (Page 15)

MDE-4390F Gasboy CFN Series NBS (GL3) Credit and Debit Card Network V 1.3.0.0 · November 2008 Page 11
Setting Up CFN III with NBS Preparing for Configuration
3 Run NBS -I to initialize the network parameters, refer to
“Initialize Current NBS Configuration (-I)” on page 15 .
4 Run NBS -E (or select Edit Network Parameters, from the menu system).
5 Select the Walkthrough edit option, W. This will step you through all the basic data needed for
the network.
6 Run MODEMS (or NBS -M) to set up the modem type, baud and channel. MODEMS can also
be used for VSAT. The baud rate for VSAT must be set to 2400 baud. The modem can be set
to 2400 or 1200 baud.
7 Reboot and run NBS -C to set the card parameters.
The product cross-reference must be set up (step 8 ) before doing any transactions.
Failure to do so will result in loss of revenue. It is critical for the following:
• The Gasboy fuel product codes are set to a fuel attribute (attribute 8) to be
properly cross referenced to the host product codes. Else, completed transactions
will be rejected resulting in loss of revenue.
• If Gift cards/Prepaid cards are to be used for balance request, activation, or
recharge, they must be set up as a Gasboy product and properly cross-referenced.
If not set up properly with the cross-reference table, the result will be a sale and not
an action to be taken on the card.
• Coupons are to be set up as Negative products on the Gasboy system (attribute
1). If they are not properly cross-referenced to a coupon code, the coupon will be
read as a sale and not a discount.
• If cash back codes are not enabled as a withdrawal (attribute 3) and properly
cross-referenced, the cash back will create an out-of-balance condition in the
system.
• Verify if all product cross-references to be used by a location are approved by the
host system. Refer to “Product Codes” on page 40 for Product codes to be sent to
the host.
Note: Using non-approved NBS product codes or non-fuel product codes for fuel
sales will result in monetary losses.
CAUTION
8 Run NBS -X to set up the product cross-reference.