Gasboy CFN Series NBS - Manual (Page 38)

Using NBS Special System Setup
Page 34 MDE-4390F Gasboy CFN Series NBS (GL3) Credit and Debit Card Network V 1.3.0.0 · November 2008
To process fleet and/or debit cards, the PIN prompt step (type 3) must be added twice,
contiguously. The first PIN step is used for the prompting of fleet cards. The second PIN step
is used to prompt for a debit card's PIN number. To avoid confusion, always include both PIN
steps, even if fleet or debit cards are not accepted.
• The first PIN step is used for local cards and some fleet cards. Newer PIN pads and
dispensers will only accept specific type of prompts for a fleet card PIN number. Some of
the most common acceptable prompts are:
Enter Personal ID
Enter Driver No
Enter Club ID
Enter Fleet PIN
Enter ID Number
• The second PIN step is used to prompt for an encoded secure PIN number, which is
associated with debit cards. Unlike the local and fleet card prompts, the second PIN
prompt is not restricted to a limited set of acceptable prompts. The most common debit
prompts are:
Enter Your PIN
Enter PIN number
Enter secure PIN
Note: The sequence number for the two PIN steps are contiguous. The second PIN step must
immediately follow the first PIN prompt and both PIN steps must be present, even if
debit or fleet cards are not accepted.
Below is an example of how the Odometer, Vehicle, and PIN prompts are used.
# Ty S/D DISPLAY WHILE ENTERING OPTIONS
1 1 ! < < Slide Card < < ! !
2 3 4 ! ENTER DRIVER NO !Driver Number ! Optional Mask
3 3 4 ! ENTER PIN NO !Your PIN ! Optional Mask
4 7 6 ! ENTER ODOMETER !Odometer ! Optional
5 6 6 ! ENTER VEHICLE # !Vehicle ! Optional
6 2 1 ! SELECT PUMP NUMBER !Pump ! Optional
7 9 ! Please Wait ! !
8 10 ! ! !
9 14 2 !Pump #XX selected ! !
10 20 2 !PROD 0.000! !
11 13 2 ! Thank You! ! !
12 !--------END---------! !
This will mask the
PIN entry.
Island Card Reader
The ICR can be used for all prompts except debit transactions. Secure debit PIN numbers
cannot be entered on the ICR.