Measurement Computing DaqBoard 1000 Series - Manual (Page 44)

1-22 Daq Systems and Device Overviews 889094 DaqBoard/1000 and /2000 Series User’s Manual
DaqBoard/2005 Block Diagram*
*The DaqBoard/2005c Block Diagram is the same, with exception that the /2005c board uses a
compact-PCI Bus instead of a standard PCI bus.
Connections
Installation
Reference Note:
For the DaqBoard/2005 and compact-PCI DaqBoard/2005c installation procedure, refer to
either the DaqBoard/1000 and /2000 Series Installation Guide or to the DaqBoard/2000c
Series Installation Guide, as applicable. The guides are included at the beginning of this
manual.
I/O Connector
All input and output signals are available at the board’s 100-pin P4 connector. A 3-foot, 100-conductor
ribbon cable, part number CA-195, mates with connector P4.
Reference Note:
There are several P4-connector board options available for connecting the 100 pins of P4 to
typical DB37 connectors (P1, P2, and P3). In addition to being briefly discussed in chapter 3
of this manual, these options, referred to as DBK200 Series, are detailed in the DBK Cards
and Modules User’s Manual (p/n 457-0905).