Measurement Computing DaqBoard 1000 Series - Manual (Page 69)

CE Enhancements for DBKs
The following CE enhancements are described in the individual document modules of the
DBK Cards and Modules User’s Manual (p/n 457-0905).
• DBK41/CE
• Edge Guard (for DBK5, DBK8, and DBK44)
• Applicable cables and connectors
CE Cable Kits for DaqBoard 2000 Series and /2000c Series Boards
CAUTION
Turn OFF the power to, and UNPLUG the host PC and externally connected equipment prior to
removing the PC’s cover and removing (or installing) the DaqBoard/2000 Series [or /2000c Series]
Board. Electric shock or damage to equipment can result even under low-voltage conditions.
Take ESD precautions (packaging, proper handling, grounded wrist strap, etc.)
Use care to avoid touching board surfaces and onboard components. Only handle boards by their
edges (or ORBs, if applicable). Ensure boards do not come into contact with foreign elements such
as oils, water, and industrial particulate.
Note: The CE Cable Kit used with DaqBoard/2000 Series Boards is p/n CA-209.
The CE Cable Kit used with cPCI DaqBoard/2000c Series Boards is p/n CA-209c.
By following these instructions correctly, your DaqBoard/2000 Series [or /2000c Series] Board will be
CE Compliant in accordance with the conditions stated on your board’s Declaration of Conformity.
If your board is already installed, you will need to remove it from the PC before proceeding. If your board
is not yet installed, proceed to the section entitled, Install the CE ORB.
Remove DaqBoard/2000 Series or /2000c Series Board from the Host PC
For DaqBoard/2000 Series Boards [PCI type]
1.
Turn the host PC’s power OFF.
2.
Turn power OFF to externally connected equipment.
3.
UNPLUG the host PC and all externally connected equipment.
4.
Remove the PC’s cover. Refer to your PC Owner’s Manual as needed.
5.
Locate the DaqBoard/2000 Series Board and carefully remove the board from its PCI slot.
For cPCI DaqBoard/2000c Series Boards [cPCI Type]
1.
Turn the compact PC’s power OFF.
2.
Turn power OFF to externally connected
equipment.
3.
UNPLUG the compact PC and all
externally connected equipment.
4.
Loosen the upper and lower lock screws
(see figure).
5.
Push the cPCI board’s injector/ejector
down to disengage the board.
6.
Slide the board free of the compact PC.
Upper Lock Screw
Injector/
Ejector
Lower Lock Screw
Removing a cPCI DaqBoard/2000c Series Board
DaqBoard/1000 and /2000 Series User’s Manual 959495 CE-Compliance 4-3