MovinCool CM25 Service Manual - Manual (Page 28)

Operation Section
28
5.4 Wall Mounted Controller (WMC)
• The WMC for this unit should be mounted within the room close to the return air grill to provide
convenient system control.
1 ON/OFF button Activates (LED illuminates green) or deactivates unit operation.
2 MODE button Activates COOL or FAN ONLY operation.
3 FAN MODE button Activates fan mode RUN or AUTO.
RUN: Fan operates continuously during COOL mode even after the room
temperature reaches the set point temperature.
RUN mode is automatically selected when FAN ONLY mode is selected.
AUTO: Fan automatically stops during COOL mode after the room temperature
reaches the set point temperature.
Fan automatically operates when the room temperature is above the set
point temperature.
4 FAN SPEED button Activates fan speed High or Low.
5 UP ( ) and DOWN () button Increases or decreases the temperature set point during COOL mode. Selects
each item when setting the clock or program.
6 PROGRAM button Sets or displays program.
7 SET TIME button Sets clock (day and time).
8 ENTER button Accepts selection and goes to the next step.
9 RUN/STOP button Activates or deactivates program(s).
10 RESET button • Clears self-diagnostic codes.
• Returns to “Day of the week” for “ON” (start) program setting during program
editing mode.
• Clears all program memory during program editing mode by pressing and
holding the RESET button for 3 seconds.
I003163
4.8 in (120 mm)
4.8 in (120 mm)
0.6 in (15 mm)
LCD Display Control Panel
8
10
4
3
2
1 5
7
6
9