Factory default output messages, Table 22: factory default nct messages/responses – NavCom SF-3050 Rev.I User Manual
Page 121
SF-3050 GNSS Product User Guide
– Rev I
102
BLUETOOTH VIRTUAL COM PORT
Configuration
– Control Port
Rate
– 230.4kbps
The PC’s virtual COM port is used to input and output proprietary messages used for
navigation and receiver setup. Table 22 describes the default messages needed to best
initiate surveying with minimal effort.
The user has full control over the utilized message types and their
associated rates via either
StarUtil 3000 or a third-party software/utility.
Factory Default Output Messages
NCT Messages
Table 22: Factory Default NCT Messages/Responses
Output on Ports COM1 and USB1
Message
Rate
Description
ALM1B
On Change
Satellite Almanac
CHNLSTATUS1B
On Time 1Hz
ASIC & StarFire Channel Status
EPHEM1B
On Change
Satellite Ephemeris
MEAS1B
On Time 1Hz
Raw Satellite Measurement Data
MSGPRODUCTINFO On Time 600 Sec
Product Type, Digital Serial
Number, and System Revision
Number
MSGVERSION
On Time 600 Sec
Firmware Identification Block
PVT1B
On Time 1Hz
Position, Velocity, and Time
(PVT) Solution
PANICA
On Change
Factory Use
Output on All Ports
Message
Rate
Description
OK (mnemonic)
On Change
Ack
(“Acknowledged”).
Ack indicates a successful input
message operation.
?? (mnemonic)
{argument error}
On Change
Nak (“Not Acknowledged”). NAK
indicates a failure in executing a
command.
PANICA
On Change
Factory Use