NavCom SF-3050 Rev.I - Manual (Page 15)

SF-3050 GNSS Product User Guide – Rev I
xiii
“NMEA-0183 Data”; added description of software bundle SF-
3050A; deleted footnotes from SF-
3050M; updated “Ethernet
Connection”; updated “Airborne”;
added photo of L1 antenna under
the L1/G1 description; updated Figure 40 to show L1 antenna;
updated “Unique Features” section: under “Multi-Format RTK,”
added Moving Base RTK and Heading; and
added “User-Defined
Datum”, “Internal Memory”, “Control of Power Consumption”,
“CORS Support”, and “NTRIP Support” bulleted items
Chapter 3: Added drawing of new power cable to Figure 80
(previously Figure 37); updated PIN assignments of updated
Ethernet cable in Table 17; updated
“Bluetooth Communications
Setup
” section and updated the graphics for Bluetooth configuration;
updated Positronic socket type connector part number:
was: P/N FR11FP9ZZLM0/AA
is: P/N FR11FP922LM0/AA
Updated description of the LOGFILE command parameters; added
Note referring user to Appendix C of the Sapphire Technical
Reference Manual;
updated the “Direct Ethernet Connection via
Static IP Address” section: added that SF-3050 supports TCP
connection in addition to UDP; referred user to Chapter 2 of the
StarUtil 3000 User Guide for detailed instructions on configuring
Ethernet connection
Chapter 5: Added “Setting Up a StarFire Priority Network” section;
updated “User Profiles” section; in section “Reassignment of
StarFire
Network List”, added table numbers to the tables and links
to those tables
Appendix A:
in “Features” section: added MBRTK and Heading;
added Heading Slew to “Measurement Performance” and updated
Velocity for all DGPS modes; added PDOP disclaimer; added Note
about RTK Extend being required only on Rover receiver; added
Note referring user to Chapter 5 of the StarUtil 3000 User Guide
;updated User-Programmable Output Rates table to include Bundle
A; added Bundle A to note re default PVT and Raw Data Rate;
a
dded “Networked Transport of RTCM Internet Protocol (NTRIP)
Setup” section; added Heading and Slew degrees to “Measurement
Performance” table
Appendix B: added antenna info for L1
Appendix C: in “Infrastructure” section: changed statement “GPS
satellites transmit navigation data on two L-
Band frequencies” to
“GPS satellites transmit navigation data on several L-Band
frequencies”; changed “dual-frequency” to “multi-frequency”
throughout this section; added a Note about SF-3050A single-
frequency operation availability; in “StarFire Satellites” section: