VXL Instruments Itona TC75yyd Series - Manual (Page 9)

Replacing RAM 5
4
Replacing RAM
1. Remove the power cord and side cover as described on page 4.
2. Apply isopropyl alcohol on the glue holding the DDR3 RAM, pull the glue out using nose
pliers.
Figure 4-1: RAM Socket Clips
3. Remove the existing RAM from the SO-DIMM slot by unlocking the holders and pulling it
outward.
Figure 4-2: Removing the RAM Module
4. Place the new DDR3 RAM in the SO-DIMM slot.
Note: Ensure that the new RAM is of the same specification as the existing RAM.