H3C Technologies H3C S5120 Series Switches - Manual (Page 653)

1-10
To do… Use the command… Remarks
system uses channel 2
(loghost) by default.
The value of the port-number
argument should be the same
as the value configured on the
log host, otherwise, the log host
cannot receive system
information.
Configure the output rules of
the system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to Default Output Rules
of System .
Specify the source IP address
for the log information info-center loghost source
interface-type interface-number
Optional
By default, the source interface
is determined by the matched
route, and the primary IP
address of this interface is the
source IP address of the log
information.
Configure the format of the time
stamp for system information
output to the log host info-center timestamp
loghost { date | no-year-date |
none }
Optional
date by default.
Outputting System Information to the Trap Buffer
The trap buffer receives the trap information only, and discards the log and debugging information even
if you have configured to output them to the trap buffer.
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name Optional
Refer to Table 1-2 for default
channel names.
Configure the channel through
which system information can
be output to the trap buffer and
specify the buffer size info-center trapbuffer
[ channel { channel-number |
channel-name } | size
buffersize ] *
Optional
By default, system information
is output to the trap buffer
through channel 3 (known as
trapbuffer) and the default
buffer size is 256.