H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 36)

27
1. Make sure the grounding cable is well grounded.
2. Attach the hooks of the bail latch into the holes on the two sides of the
AC-input power receptacle, and pull the bail latch upwards.
3. Connect one end of the AC power cord to the AC-input power
receptacle on the wireless switch.
4. Pull the bail latch down to secure the plug to the power receptacle.
5. Connect the other end of the power cord to the AC power outlet.
Figure 17 Connecting an AC power cord
6. Check the PWR LED.
Table 10 PWR LED status
LED Mark Status Description
System status
LED
(green/red)
PWR
Steady green
The wireless switch is
performing POST or
downloading software.
Flashing green
The wireless switch is
operating properly.
Steady red
POST has failed or other
serious faults are detected.
Off No power is input.