HEIDENHAIN TNC 310 (286 140) - Manual (Page 108)

8 Programming: Cycles 96
8.2 Drilling Cycles
The TNC offers 8 cycles for all types of drilling operations:
Cycle Soft key
1 PECKING
Without automatic pre-positioning
200 DRILLING
With automatic pre-positioning and
2nd set-up clearance
201 REAMING
With automatic pre-positioning and
2nd set-up clearance
202 BORING
With automatic pre-positioning and
2nd set-up clearance
203 UNIVERSAL DRILLING
With automatic pre-positioning,
2nd setup clearance, chip breaking, and decrement
204 BACK BORING
With automatic pre-positioning,
2nd set-up clearance
2 TAPPING
With a floating tap holder
17 RIGID TAPPING
Without a floating tap holder
8.2 Dr
illing Cy
cles