HEIDENHAIN TNC 310 (286 140) - Manual (Page 225)

213 HEIDENHAIN TNC 310
13.3 Entering the Code Number
To enter the code number, press the soft key with the key symbol.
The TNC requires a code number for the following functions:
Function Code number
Select user parameters 123
Cancel file protection 86357
Operating hours counter for:
CONTROL ON
PROGRAM RUN
SPINDLE ON
857282
13.4 Setting the Data Interface
Press the soft key marked RS 232 SETUP to call a menu for setting
the data interfaces:
Setting the OPERATING MODE of the external
device
External device RS232 INTERFACE
HEIDENHAIN floppy disk unit
FE 401 and FE 401B
FE
Non-HEIDENHAIN devices such as
Punchers, PC without TNC.EXE
EXT1, EXT2
PC with HEIDENHAIN software
for data transfer - TNCremo
FE
No data transfer; e.g. working
without a connected external device
none
Setting the baud rate
You can set the baud rate (data transfer speed) from 110 to 115,200
baud. For each operating mode (FE, EXT1 etc.), the TNC stores an
individual baud rate. When you select baud rate using an arrow key,
the TNC recalls the value that was last stored for this operating
mode.
13.3 Ent
er
ing the Code Number;
13.4 Set
ting the D
ata Int
erf
ace