Error message table – Casio fx-CG Series Screen Receiver User Manual

Page 27

Advertising
background image

E-26

5. Error Message Table

Message

Description

Required Action

A problem occurred while
writing file <file name>.
The disk being written to may
be damaged or may not exist.
Check the disk and try again.

A problem occurred while
writing to a disk.

Check the disk for data
corruption and confirm that
the disk exists. Then try
again.

A problem occurred while
launching the manual (***.pdf)
viewer.
Download the viewer from the
site below and reinstall it.
http://get.adobe.com/reader/
otherversions/

A problem occurred during
manual viewer startup.

Download and install a new
viewer from
http://get.adobe.com/reader/
otherversions/ .

The path and/or filename
exceeds the maximum length
allowed by your Windows*
operating system.

The number of letters in
the path or file name you
specified exceeds the
allowable limit.

Shorten the specified path or
file name.

A connection could not be
established.
Either the calculator is not
connected or the connected
calculator is not in the Screen
Receiver Mode.
Correct the problem and try
again.
For details, select the
following on the menu bar:
Help - Manual, or refer to the
Screen Receiver user’s guide.

You started a data
communication operation
while the USB cable was not
connected.

Check for proper connection
of the calculator to the
computer. Then try again.
See “3. Using Screen
Receiver” for details.

A problem occurred during
communication.
Disconnect the USB cable,
check the setup of the
calculator, and try again.
For details, select the
following on the menu bar:
Help - Manual, or refer to the
Screen Receiver user’s guide.

Some problem occurred
during data communication.

Disconnect the USB cable
and check the setup of the
calculation. Then try again.
See “3. Using Screen
Receiver” for details.

Advertising
This manual is related to the following products: