Caution, Maintenance – Exmark Metro 26 EN User Manual
Page 23
- 18 -
5. MAINTENANCE
NOTE: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Service Interval
Maintenance Procedure
Each Use
• Check the engine oil level.
• Check the stopping time of the blade brake. The blade must stop
within 3 seconds of releasing the bail; if it does not; contact an
Authorized Service Dealer for repair.
• Remove grass clippings and dirt from under the housing.
• Clean the discharge tunnel area
5 Hours
• Check the blade and the engine mounting fasteners. Tighten them
if they are loose.
50 Hours
• Change the engine oil (without the oil filter).
1
• Sharpen or replace the blade; maintain it more frequently if the
edge dulls quickly in rough or in sandy conditions.
• Clean the blade brake clutch shield.
• Check for leaks in the fuel system and/or a deteriorating fuel hose.
Replace parts if necessary.
• Remove grass clippings and debris from under the belt cover.
• Lubricate the pivot arms.
75 Hours
• Adjust the self-propel drive system.
100 Hours
• Change the oil filter.
• Inspect the spark plug and replace it if necessary.
• Clean the cooling system; remove grass clippings, debris, or dirt
from the engine air cooling fins and starter. Clean the system more
frequently in dirty or high-chaff conditions.
• Lubricate the gear case.
• Adjust the blade brake cable.
• Service the wheels.
300 Hours
• Replace the paper air filter. Replace it more frequently in dusty
operating conditions.
Storage
• Empty the fuel tank before repairs as directed or before storage.
1
Change the engine oil after the first 5 operating hours.
NOTE: Refer to your engine operator’s manual for additional maintenance procedures.
CAUTION
POTENTIAL HAZARD
♦ If you leave the wire on the spark plug, someone could
accidentally start the engine.
WHAT CAN HAPPEN
♦ Accidental starting of the engine could seriously injure
you or other bystanders.
HOW TO AVOID THE HAZARD
♦ Disconnect the wire from the spark plug before you don
any maintenance. Set the wire aside so that it does not
accidentally contact the spark plug.
5.1 Checking the Engine Oil Level
Service Interval: Before each use.
Make sure that the oil level is between the Add and the Full marks as shown on the
dipstick (Fig. 4). If the oil level is below the Add mark, add oil. Refer to Section 3.4.1
Filling the Crankcase with Oil.
- Lazer Z XS lXs29lKa725
- E-Series
- Pioneer S-Series Lawn Mower PNS20KA443
- Ultra VAC LAZER AS
- Ultra Vac 4500-420
- FMD604
- Quest Bagger 000 & higher
- Mhp3615ka
- Lazer ZCT
- Lazer ZXP
- METRO 21 MPKA21
- Vh4815ka
- Commercial 21 4500-686 Rev. B
- Turf Tracer S-Series TTS18KA523
- lazer Z E-Series 0
- FontRunner FR27
- NAV27KC
- Metro 21
- Metro 26
- Navigator 4500-368
- LAZER Z D-SERIES Mower 0
- Quest Lawn Mower
- Turf Tracer TT23KCC
- Vantage VT691KA524CA
- Lazer Z 4500-485
- Frontrunner
- Lawn Tractor
- Pioneer S-Series 312
- Standon 4500-436
- Lawn mower COMMERCIAL 21
- TT4817KA
- Turf Tracer S-Series 312
- LAZER Z 4500-484
- Mhp4815kac
- Phazer PHZ19KA343CA
- OCD01
- Lazer Z CT
- Lazer Z Mower 4500-507
- Turf Tracer HP 4500-358
- Vikingtm Hydro 4500-355
- LAZER Z 4500-471
- Lazer Z Advantage Series X
- Frontrunner 4500-497
- lazer Z 000 & Higher
- Lazer Z HP 505
- Turf Tracer x-series LP FMD604
- NAVIGATOR 4500-367
- Mower Pioneer E-Series 4500-996 Rev A
- Lazer Z 4500-872
- LAZER ZTM
- Quest Bagger 4500-438 rev. a
- Metro 21 Series
- FR20KC
- Lazer Z SX Diesel Models 4500-501 Rev A
- LZ27KC604
- Viking VH15KA483 ECS 15
- Lazer Z HP 465
- Commercial 21 000 & higher
- Metro 4500-353
- Navigator 850
- M217bsp
- OCD02
- Lazer ZHP
- Quest 4500-451
- Lazer Z XS
- Ultra Vac QDS 850
- FrontRunner Air-Cooled
- VH15KA362
- Cd48cd
- Standon 4500-435
- Lazer Z Advantage Series
- Turf Tracer HP 4500-359
- Lazer Z Mower 4500-645
- 4500-371
- TT23KAEP
- Quest 4500-450
- NAV20KC
- Phazer 4500-461
- Ultra Vac Lazer Z AS
- Ultra Vac 4500-421
- FR604
- Self Propelled Mower
- Frontrunner 4500-341
- Phazer 820
- Lazer Z D-Series 000 & higher
- Turf Tracer HP 4500-540 Rev. B
- FMD524
- Turf Tracer 4500-528
- M216KASPC
- 4500-370
- FrontRunner Diesel
- TR23KC
- Lazer Z XP
- Lazer XS 4500-380
- Phazer
- Turf Tracer TT23KAE
- FR524
- M216KASP
- Quest Bagger
- Ultra Vac
- Lazer Z
- QUEST 4500-339
- LAZER Z 103-0656
- Advantage Series 4500-466
- FMD 604
- Pioneer S-Series 000 & Higher
- Lazer Z DS-Series LZDS
- Lazer HP
- Metro 4500-352
- Lazer Z Advantage Series Models 850
- Metro
- Lazer Z S-Series