Exmark Metro 26 EN User Manual
Page 28
- 23 -
9. Re-install a sharp balanced Exmark blade, spacer, washer, and blade bolt. The sail of
the blade must point toward the top of the lawn mower housing for proper installation.
Torque the blade bolt to 75-85 ft-lb (102-115 N-m).
10. Return the lawn mower to its upright position.
11. Close fuel valve and refuel.
12. Connect the wire to the spark plug.
5.7 Cleaning Under the Cover:
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 8).
3. Remove the screws that secure the belt cover to the lawn mower housing (Fig. 22).
4. Lift off the cover and brush out all the debris around the belt area.
5. Install the belt cover.
6. Connect the wire to the spark plug
5.8 Emptying the Fuel Tank and Cleaning the Fuel Filter:
Service Interval: Clean the fuel filter element every 100 operating hours.
The fuel filter (screen) element is located inside the fuel tank.
1. Stop the engine and wait for it to cool down.
NOTE: Drain gasoline for a cold engine only.
2. Disconnect the wire from the spark plug (Fig. 8).
3. Close the fuel valve located in the tank under the fuel cap by rotating the fuel valve
knob clockwise.
4. Disconnect the fuel line (Fig. 3) by loosening the tube clamp at the carburetor.
5. Open the fuel valve to the open position.
6. Drain the gasoline completely from the tank and fuel line into an approved fuel
container.
7. Remove the fuel tank from the mower.
8. Close the fuel valve.
9. Pour a small amount of fuel in the fuel tank, move the fuel around in the tank, and
pour it out into an approved fuel container.
10. Install the fuel tank and fuel line.
5.9 Lubricating the Pivot Arms
Service Interval: Lubricate after every 50 operating hours or when the season ends.
1. Move the rear wheel cutting height levers to the center setting.
FIGURE 22
- Lazer Z XS lXs29lKa725
- E-Series
- Pioneer S-Series Lawn Mower PNS20KA443
- Ultra VAC LAZER AS
- Ultra Vac 4500-420
- FMD604
- Quest Bagger 000 & higher
- Mhp3615ka
- Lazer ZCT
- Lazer ZXP
- METRO 21 MPKA21
- Vh4815ka
- Commercial 21 4500-686 Rev. B
- Turf Tracer S-Series TTS18KA523
- lazer Z E-Series 0
- FontRunner FR27
- NAV27KC
- Metro 21
- Metro 26
- Navigator 4500-368
- LAZER Z D-SERIES Mower 0
- Quest Lawn Mower
- Turf Tracer TT23KCC
- Vantage VT691KA524CA
- Lazer Z 4500-485
- Frontrunner
- Lawn Tractor
- Pioneer S-Series 312
- Standon 4500-436
- Lawn mower COMMERCIAL 21
- TT4817KA
- Turf Tracer S-Series 312
- LAZER Z 4500-484
- Mhp4815kac
- Phazer PHZ19KA343CA
- OCD01
- Lazer Z CT
- Lazer Z Mower 4500-507
- Turf Tracer HP 4500-358
- Vikingtm Hydro 4500-355
- LAZER Z 4500-471
- Lazer Z Advantage Series X
- Frontrunner 4500-497
- lazer Z 000 & Higher
- Lazer Z HP 505
- Turf Tracer x-series LP FMD604
- NAVIGATOR 4500-367
- Mower Pioneer E-Series 4500-996 Rev A
- Lazer Z 4500-872
- LAZER ZTM
- Quest Bagger 4500-438 rev. a
- Metro 21 Series
- FR20KC
- Lazer Z SX Diesel Models 4500-501 Rev A
- LZ27KC604
- Viking VH15KA483 ECS 15
- Lazer Z HP 465
- Commercial 21 000 & higher
- Metro 4500-353
- Navigator 850
- M217bsp
- OCD02
- Lazer ZHP
- Quest 4500-451
- Lazer Z XS
- Ultra Vac QDS 850
- FrontRunner Air-Cooled
- VH15KA362
- Cd48cd
- Standon 4500-435
- Lazer Z Advantage Series
- Turf Tracer HP 4500-359
- Lazer Z Mower 4500-645
- 4500-371
- TT23KAEP
- Quest 4500-450
- NAV20KC
- Phazer 4500-461
- Ultra Vac Lazer Z AS
- Ultra Vac 4500-421
- FR604
- Self Propelled Mower
- Frontrunner 4500-341
- Phazer 820
- Lazer Z D-Series 000 & higher
- Turf Tracer HP 4500-540 Rev. B
- FMD524
- Turf Tracer 4500-528
- M216KASPC
- 4500-370
- FrontRunner Diesel
- TR23KC
- Lazer Z XP
- Lazer XS 4500-380
- Phazer
- Turf Tracer TT23KAE
- FR524
- M216KASP
- Quest Bagger
- Ultra Vac
- Lazer Z
- QUEST 4500-339
- LAZER Z 103-0656
- Advantage Series 4500-466
- FMD 604
- Pioneer S-Series 000 & Higher
- Lazer Z DS-Series LZDS
- Lazer HP
- Metro 4500-352
- Lazer Z Advantage Series Models 850
- Metro
- Lazer Z S-Series