MCZ Omega '05 - Manual (Page 23)

PELLET STOVE Chapter 3
INSTALLATION AND USE MANUAL page
22
Installation and assembly Technical service – Rights reserved MCZ S.p.A. – Reproduction prohibited
EN
G
L
IS
H
3.2. PREPARATION AND PACKAGING
Saturn, Omega and Planet stoves are delivered in two packages:
The first contains the body (Fig. 1)
The second contains the ceramic cladding (Fig. 2)
Open the packaging, take off the bands, remove the stove unit from
the pallet and position it in the chosen location, taking care that its
position complies with the above instructions.
The main stove unit must always be moved in an upright position and a
trolley must always be used. Take particular care to see that the door
and its glass are protected from mechanical impact which could
damage them.
Moving the product must always be done with care.
If possible unpack the stove near the place where it will be installed.
The materials which make up the packaging are not toxic or harmful,
so no special procedures for disposal by required.
Their storage, disposal or possible recycling are therefore the
responsibility of the final user, in compliance with current legislation on
the subject.
Do not store the stove unit or its cladding without their packaging.
If the stove needs to be connected to a discharge pipe which goes
through the rear wall (to connect up with the flue), take the greatest
care to make sure that the joint is not stressed.
Adjust the 4 feet (J) the smoke discharge (S) and the pipe (H) are
coaxial.
If the smoke discharge of the pipe is forced or
improperly used to lift if or move, its operation will
be irreparably compromised.
Figure 2 – Example of ceramic packaging
1. Rotate the foot
clockwise to lower the
stove
2. Rotate the foot
counterclockwise to
raise the stove
S
H
Seen
from
below
J
Foot J