RIGOL MSO/DS1000Z Series User Manual

Page 107

Advertising

RIGOL

MSO1000Z/DS1000Z User’s Guide

5-33

selected:

--press Data Bits to select "5 bits", "6 bits", "7 bits" or "8 bits";
--press Data and use

to set the data value of RS232 trigger. According to

the setting in Data Bits and the ranges can be from 0 to 31, from 0 to 63, from

0 to 127 or from 0 to 255 respectively.

Baud Rate:

Set the baud rate of data transmission (equal to specifying a clock frequency). Press

BaudRate to set the desired baud rate to 2400 bps, 4800 bps, 9600 bps (default),

19200 bps, 38400 bps, 57600 bps, 115200 bps, 230400 bps, 460800 bps, 921600

bps, 1 Mbps and user-defined. When "User" is selected, press Setup to set a more

specific value from 110 bps to 20000000 bps with an adjustment step of 1 bps. For

the setting method, please refer to the introduction in "Parameter Setting

Trigger Mode:

Press Sweep to open the trigger mode list and select auto, normal or single. For the

details, please refer to "

Trigger Mode". The corresponding status light of the

current trigger mode turns on.

Trigger Setting:

Press Setting to set the trigger parameter (noise rejection) under this trigger type.

Trigger Level:

When the trigger source is an analog channel, you can use TRIGGER LEVEL to

modify the level. For the details, please refer to the introduction of "

Advertising