KEPCO KLN 750W Series, Firmware Version 1.60 to 1.6x - Manual (Page 51)

KLN 750W 032614
3-15
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (CV.M) to access CONSTANT VOLTAGE MODE CONTROL setting.
2. Press ENTER key to view setting.
LOCAL (front panel) mode displayed as (LOC) in Current display.
EXTERNAL (Programming Control port) mode displayed as (EXT) in Current
display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.27 ENABLE CURRENT CONTROL VIA PROGRAMMING CONTROL PORT
Allows current control either from the front panel (LOCAL) or from the analog signal via the Pro-
gramming Control port (EXTERNAL)
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (CC.M) to access CONSTANT CURRENT MODE CONTROL setting.
2. Press ENTER key to view setting.
LOCAL (front panel) mode displayed as (LOC) in Current display.
EXTERNAL (Programming Control port) mode displayed as (EXT) in Current
display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.28 CALIBRATION ACCESS
Allows access to calibration mode which is password protected.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (CAL) to access CALIBRATION mode.
2. Press ENTER key to access setting (password).
3. Rotate encoder until Current display shows desired setting for blinking digit.
4. Tap encoder to go to next digit and repeat step 3 for all digits of the password, then press
ENTER to confirm.
5. Refer to PAR. 4.1 to calibrate the unit.
3.3.29 VIEW SERIAL NUMBER
Allows viewing of 6-digit serial number.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (SN) in the two left-most characters.
2. Serial Number displayed starting with two right-most digits (10) in Voltage dis-
play and four digits in Current display (0000).