ProSoft Technology MVI69E-LDM User Manual
Page 25
MVI69E-LDM ♦ "C" Programmable
Contents
Linux Application Development Module
Developer's Manual
ProSoft Technology, Inc.
Page 25 of 130
August 21, 2014
Ethernet (Telnet)
You can communicate with the module through Ethernet Port 1 (Eth 1) using Telnet.
The Ethernet Port (Eth 1) on the module is programmed with eth0 set to IP 192.168.0.250
and a Subnet Mask of 255.255.255.0. In order for your PC or laptop to talk to the module,
your PC or Laptop must be on the same subnet as the module. This means that you must
temporarily change the IP address and subnet mask on your PC or laptop to match that of
the module. You can then change the module's IP address to match your needs. Follow
these steps or see http://windows.microsoft.com/en-us/windows/change-tcp-ip-
settings#1TC=windows-7
1 Change the IP address of your PC or Laptop so it matches the subnet of the module.
The following steps are for Windows 7.
a Change your IP address through the router. Consult your router documentation for
more information.
b Change your IP address through Windows Network Connections. Click S
TART
>
C
ONTROL
P
ANEL
> N
ETWORK AND
S
HARING
C
ENTER
.
c Click the C
ONNECTION
link for the connection you want to change and choose
P
ROPERTIES
.
d On the Local Area Connection Properties dialog, select the connection you want to
change (Internet Protocol Version 6 or Internet Protocol Version 4), and then click
P
ROPERTIES
.
e In the Internet Protocol Version 4 or 6 Properties dialog, click U
SE THE FOLLOWING
IP
ADDRESS
.
f
Type in the IP address settings for the IP
A
DDRESS
, S
UBNET MASK
, and D
EFAULT
GATEWAY
.
g Click OK to accept the changes and then close each of the dialog boxes.
2 Ensure that an Ethernet cable is connected to Ethernet Port 1 (Eth 1) of the module, and
the other end to the same Ethernet switch as your PC.