ProSoft Technology MVI69E-LDM - Manual (Page 3)

Warnings, Specification, and Certifications
North America Warnings
A Warning - Explosion Hazard - Substitution of components may impair suitability for Class I, Division 2.
B Warning - Explosion Hazard - When in Hazardous Locations, turn off power before replacing or rewiring
modules.
C Warning - Explosion Hazard - Do not disconnect equipment unless power has been switched off or the area is
known to be non-hazardous.
D Suitable for use in Class I, Division 2 Groups A, B, C and D Hazardous Locations or Non-Hazardous Locations
only.
E The subject devices are powered by a Switch Model Power Supply (SMPS) that has a regulated output voltage
of 5 VDC.
ATEX Warnings and Conditions of Safe Usage:
Power, Input, and Output (I/O) wiring must be in accordance with the authority having jurisdiction
A Warning - Explosion Hazard - When in hazardous locations, turn off power before replacing or wiring modules.
B Warning - Explosion Hazard - Do not disconnect equipment unless power has been switched off or the area is
known to be non-hazardous.
C These products are intended to be mounted in an IP54 enclosure. The devices shall provide external means to
prevent the rated voltage being exceeded by transient disturbances of more than 40%. This device must be used
only with ATEX certified backplanes.
D DO NOT OPEN WHEN ENERGIZED.
CPU, Memory, and OS Specifications
 CPU: 400MHz ARM9 G20
 Operating System: Linux (kernel 2.6.
33.7)
 Linux Distribution: BusyBox
 System Memory: 64MB SDRAM
 Flash Memory: 256MB NAND Flash
General Specifications
 Backplane Current Load: 500 mA @ 5 VDC; 3mA @ 24 VDC
 Operating Temperature: 0 to 60°C (32 to 140°F)
 Storage Temperature: -40 to 85°C (-40 to 185°F)
 Shock: 30g non-operational; 15g non-operational; Vibration: 5 g from 10 to 150 Hz
 Relative Humidity: 5% to 95% (without condensation)
 LED Indicators: ETH - Application driven, P1 Application Driven, P2 Application driven, CFG - Application
driven, BP - Application driven, OK - Application driven
Ethernet Ports
 1 Ethernet port
 10/100 Mbps
 RJ45 connector
 Link and Activity indicators
 Auto-sensing crossover cable detection
Serial Ports
 Full hardware handshaking control provides radio, modem, and multi-drop support.
 2 Serial Application ports: RJ45 (DB-9M with supplied adapter cable)
 Configurable RS-232 hardware handshaking
 500V Optical isolation from backplane
 RS-232, RS-422, RS-485 (software configurable by the end user)
 Rx (Receive) and Tx (Transmit) LEDs, each port