Icron Mounting Kit for Ranger 2304, 2324, 2344, 2304GE-LAN, and Spectra 3022 - Manual (Page 14)

OPTION 2: USB Extender Direct Surface Mounting (using your own hardware)
The bottom of the Ranger 2304GE-LAN enclosures features four pre-drilled holes for optional surface
mounting.
Distance between the enclosure mounting holes:
42.0mm x 77. 0mm
1. Mark the center point of each of the four holes on your mounting surface either by directly measuring or
using a print out of the stencil below.
2. Hardware recommendation: M3.0 locking washers and M3.0 screws (4 of each per extender) noting
screw length will depend upon thickness of mounting surface.
3. Drill through each of the four-hole markings on the mounting surface using a 4.7625mm (3/16”) drill bit.
4. Align the bottom enclosure holes to the newly drilled out holes on the mounting surface.
5. Place a locking washer on each of the four screws and using a screwdriver, fasten the extender into place.
To ensure the stencil below prints to scale be sure to set the page scaling setting to “none”.
42.0mm (1.6535'')
4.8mm (3/16'')
(4 Places)
77.0mm (3.0315'')
mounting hole
Direct Surface Mounting Measurement Stencil
note
13