Hisense HAIO163 163" Full HD HDR All-in-One LED Commercial Display - Manual (Page 48)

43
Cabinet fixation
(4)Use the same method to secure No. 34 cabinet (or No. 33 cabinet). Then use the two
stainless steel stepped screws shown in the Figure to fix the sides of the two cabinets, adjust
the front surface of the cabinet and the flatness of the upper side, and then tighten the screws.
You can also pre-connect the sides of No. 33 and No. 34 cabinet to form a set of cabinets,
and then fix to the bottom beam on the whole.
(5)On the two cabinets of No. 33 and No.34, it is locked with the screws for fixing the rear
connecting block, and with the screws for fixing the bottom beam (Media Bar)
Detail A
Detail B
Detail A
Detail B
LED All-In-One User Manual
(6) Fix No. 32, 35, 31, 36 cabinets in sequence in the same way as above.
Note that where there is no rear connecting block, there is need to fasten corresponding screws.
(7) Check the flatness of the cabinet, and check the front, rear, left and right positions of the
cabinet and the bottom beam.
(8) Fix the cabinets in the second row, the cabinets in the third row until the cabinets in the sixth
row, in the order of fixing cabinets in the lowest row. At the same time, check the flatness of
cabinet, and ensure that the segment difference between the left side and the right side of each
row is uniform.