Native Instruments KOMPLETE KONTROL S88 MK2 88-Key Controller for KOMPLETE - Manual (Page 245)

Available Arpeggiator Parameters
▪ To switch between Arp and Note Repeat mode and change the playback direction of the
arpeggiator sequence, use the MAIN parameters Mode and Type .
▪ To create interesting rhythms for the arpeggiator sequence, use the RHYTHM parameters
Rate , Sequence , and Swing .
▪ To change the range of available notes for the arpeggiator sequence, as well as their veloci-
ty and length, use the OTHER parameters Octaves , Dynamic , and Gate .
▪ To explore alternative versions of the same arpeggiator sequence, use the ADVANCED pa-
rameters Retrigger , Repeat , Offset , and Inversion .
▪ To change the range of keys that trigger the arpeggiator sequence, use the RANGE parame-
ters Min. Key and Max. Key .
▪ To latch the playback of the arpeggiator sequence, use the HOLD parameter.
16.5 MAIN Parameters
The MAIN parameters Mode and Type allow you to switch between Arp and Note Repeat mode
and change the playback direction of the arpeggiator sequence.
The MAIN parameters Mode and Type .
16.5.1 MAIN Mode
The first MAIN parameter is Mode . On the keyboard, it is mapped to Knob 1 of the Control
section in Arp Edit mode. lt lets you select either Arp or Note Repeat . Depending on your se-
lection, a different set of Arpeggiator parameters will be available for further editing.
Smart Play – Playing and Editing Arpeggiator Sequences
MAIN Parameters
KOMPLETE KONTROL S-Series - Manual - 245